Steamer Device

You will need 100% pure acetone to use it.

Melting time: Gel polish 3-5 min., resin and powder 6-8 min., gel acrylic 8-10 min.

1. Run the gold file over the surface of your nails;
2. Place the plastic container in the bottom of the device and pour 5 ml of acetone or non-acetone nail polish remover into it;
3. Turn on the Steamer device and wait for it to change from H (heating) to S (ready to Steamer). This step can take up to 2 minutes;
4. Place your 5 fingers in the device for approximately 3 to 5 minutes;
5. Turn off the device. Use the polishing block (or the zebra banana file) to remove the residue;
6. Turn on the device and wait for the light signal to change from H (heating) to S (ready to Steam);
7. Repeat steps 4 and 5 until there are no more residues.

– You must turn off the device when you reach step #5 (if you plan to repeat step #4) Otherwise the device will lose its heat and this will prevent the device from being in H and S mode at the same time time.
– W mode means Warm, you need to turn off the device and start from the starting point. The unit turns to W when the lid is on top and not in use (e.g. in step 5).
– You should not scrape the natural nail with an orange stick or a cuticle pusher to remove the residue in step #1. This will damage your natural nails.
– The steamer box includes two containers as well as five replacement pads.